ATM  toy  piggy bank

News

OEM, ODM and other customized service is available.

Home > 
  • News
  • >
  • Industry News
  • Nail Polish Dryer principle

    Time:2023-04-06 Views:1


    The work principle and use process of this utility model: The internal setting of the dryer shell is equipped with heating board 5, a fixed board 7 on the outside of the heating board 5, LED lamp beads 6 on the fixed board 7, and LED lamp bead 6 produced by 6. Ultraviolet rays cause the light -efficient cohesion in nail glue to solidify the reaction, and heated with heating board 5 to dry the nail polish. Open the control switch 9 during use. Start the work with LED Lighting Pearl 6 to dry nail polish. In order to enable the waiting time for drying nail polish, you can use mobile phone entertainment. There is a support board 19 above the dryer case. 19. When drying nail polish, you can use your mobile phone to watch videos. In order to ensure that the mobile phone will not fall, there is a baffle 20 in the lower end of the support board 19, and the shield 20 can effectively make the mobile phone close to the surface 19 surface 19 and bake There is a first fixed fixture 21 on the top 1 of the trunk case 1, the first fixed fixing fixture 21 is set with a activity rod 22 on the right side, the second fixed fixed fixture 23 is set on the right side of the activity rod 22, and the second fixed fixture 23 is installed in the middle of the support board 19th. Through the rotation of the activity rod 22, the angle of the support board 19 can be adjusted, it can ensure that the mobile phone has a good viewing angle, which is convenient for use when drying the nail polish. At the same time, the support board 19 is set with slider 16 and the slide block 16 is opened. There is a card 18, a fixed convex block 17 at the bottom end of the slider, and a connecting groove with a connection groove with a fixed convex block 17 and the top of the dryer shell 1. , Move to the right position, use the card 18 to hold the baffle 20, so that the support board 19 will not slide easily when placing the mobile phone, reduce the damage of the mobile phone caused by the sliding of the support board 19, and set the left end settings of the dryer case. There is a wiring rack 2, you can place the headphone cable for easy use. There is a charging device on the left left of the dryer case, the top of the dryer case 1 is opened with a charging hole 3, and the USB connector 13 is set up above the charging hole 3 for mobile phone charging and use. In order to facilitate the extension and recycling of the USB joint 13, there is a rotor 10 below the USB joint 13, the handle 11 is set on the left left, the rotary 10 is opened with a installation slot 14, the installation slot 14 is opened on the left with a line hole 15, Electric wire 12 extends through the outlet hole 15 within the installation slot 14, and then wraps around the rotating axis 10. Drops the USB connector 13 when used, drives the electric wire 12 to extend, does not use USB connector 13 charging, rotating the handle 11, driving the rotary 10 rotation 10 rotation , Follow the wire 12 and USB connector 13, so that the wire 12 is extended from the line hole 15, which can ensure that the rotating shaft 10 can effectively wrap the wire 12 to the rotating axis 10, thereby recover the USB joint 13.


    Share:

    Shenzhen Meizhigao Technology Company Limited. Shenzhen Meizhigao Technology Company Limited.

    Shenzhen Meizhigao Technology Company Limited. Shenzhen Meizhigao Technology Company Limited.

    Shenzhen Meizhigao Technology Company Limited.